This driver version was released to accommodate for the Security compliance that windows 8 has incorporated.
NOTE: The TNG service will need to be turned off. If you are unsure about how to stop and start the service follow this link:
How do I stop/start the TNG service in Windows?- Access the Device manager and locate the buffer that needs the driver software
It would be either USB Serial Port / SS-68 Data buffer/ (the device that populates when you plug in the buffer)
- Right click on that device and “Update driver software”
- Choose the “Browse my computer for the driver software” then select “Let me pick from a list of device drivers on my computer”
- This will then open a list of all possible drivers to choose from. Select the option “Next”
- Now Select option “Have Disk”
- This will then open a window that will allow you to browse to the folder location where the drivers are located
- Once you have located the software find the file called “ftdibus.inf”. Select the file and choose “Open”
- You can now choose “OK” and “Next”.
- Windows 8 will then state a Warning which just states that the software is not recognised by Windows and that you understand. Just click on “Yes”
- The Driver will then be installed with the USB section of the software. You will now need to install the Port section of the software which will allocate a COM number to the device e.g USB Serial Port (COM3)
- Once this process is done, follow steps 1 till 6 again but this time install “ftdiport.inf” and continue the steps to complete the full installation
The device should now have created a COM port as mentioned. Now switch on the TNG service again and log onto TNG :
How do I stop/start the TNG service in Windows?