Onyx connected for recording on Krone Block

Moderators: Leon van Heerden, Luanda_Junzi

Onyx connected for recording on Krone Block

Postby Therlow » Wed Sep 21, 2011 6:11 pm

I have found that when using only two of the tx and rx cables the Onyx unit initiates recording but does not get any stop signal.

Use all 4 cables and connect as below.
Connect both Pin 1 and 4 to tx
Connect both Pin 2 and 3 to rx
Therlow
 
Posts: 21
Joined: Tue Jan 11, 2011 7:11 am

Return to Support Archive's (ONYX)

Who is online

Users browsing this forum: No registered users and 1 guest