Voiprecoder, VoipSweeper and SIP Recorder FailOver config

Notes on the latest release of all Amethyst Applications

Moderators: Leon van Heerden, Luanda_Junzi, Belinda Frick, Lee Hendricks

Voiprecoder, VoipSweeper and SIP Recorder FailOver config

Postby Leon van Heerden » Wed Mar 19, 2014 7:16 pm

The Failover facility allows 2 recording servers that are recording the same set of extensions to be configured in a Master and Slave configuration. The MASTER's recordings will always be uploaded to the Amethyst server and the SLAVE recordings will be deleted once it has been confirmed as recorded by the MASTER. If the MASTER goes down, the SLAVE recording are upload to the Amethyst server.

Minimum versions required to configure fail over:
Code: Select all
VoipRecoder: 1.6.4.26
VoipSweeper: 1.6.4.31
SipRecorder: 1.6.4.39


Each application now has a FAILOVER section in the INI file.

Recorder INI file on master
Code: Select all
[FAILOVER]
MASTER=1
LISTENPORT=37002
OTHERHOST=x.x.x.x
OTHERPORT=37003


Sweeper INI file on master
Code: Select all
[FAILOVER]
MASTER=1
LISTENPORT=37004
OTHERHOST=x.x.x.x
OTHERPORT=37005


Recorder INI file on slave
Code: Select all
[FAILOVER]
MASTER=0
LISTENPORT=37003
OTHERHOST=y.y.y.y
OTHERPORT=37002


Sweeper INI file on slave
Code: Select all
[FAILOVER]
MASTER=0
LISTENPORT=37005
OTHERHOST=y.y.y.y
OTHERPORT=37004


Because the VoIPSweeper normally used the VoIPRecorder INI file, and the FAILOVER sections cannot be shared, the VoIPSweeper was changed to use its own INI file - voipsweeper.ini.
----
Leon van Heerden
http://www.datatex.co.za
Leon van Heerden
 
Posts: 332
Joined: Fri Oct 29, 2010 11:21 am
Location: Cape Town

Return to Releases

Who is online

Users browsing this forum: No registered users and 1 guest