Mitel Navigator extension set up for use with Amethyst SRC

[Belinda Frick]

The configuration is the same as Mitel 5215 except for the Jitter Buffer it does not have that display



Instructions:

Reboot the phone and then hold down the UP VOLUME key until the display shows
"Set Static IP Param?"
Press "#" for YES.
When it displays "Use Present Settings" press "#" to continue.
Press the DOWN VOLUME key until "Input RTC Address" is displayed.
Enter the SRC IP Address. Press "#" where a dot has to go.
If you blank this value out, then the PBX will be used again in place of the SRC.
Press "*" for NO for "Technician IP Addr".
Press "#" to save to the NVRAM. Wait for the save to finish and then let the phone reboot.

Once this is complete the phone will reboot and connect to the SRC, load firmware and
then boot normally. Once this is done, then you will be able to make normal phone calls.

Phone recepeption and ask that they read the extension number to you. Once this is done,
you will be able to go to Amethyst and list to the call.