Amethyst 1.5 cardserver released. Version : 1.5.1.0

[John Richard Procter]

Motivation

When configuring the amtcards for various PRI / Analogue cards it becomes
very difficult to check that all line numbers are correctly configured.
Would it be possible to have the debugging log include received
Topaz/Tapi/SMDRlink packets and the associated card references to allow the
technician to check that the lines / ports are correctly
configured/associated.
In the past when using the first versions of the PRIcard software, you were
able to see the streamed packets from Topaz allowing you to check your work.
Using the web interface the delays doesn't allow for this check.

CompletionWhen the card server is in debug mode, all the received messages
will be logged.
This will help to find problems and to check the configuration.

Motivation
Amethyst uses the board numbers to do its mapping.
The board numbers can change when a new card is installed and this can break the mapping.
Amethyst should use the PCI slot number to do the mapping.
This will not change when a new card is installed.

Completion
The card server will map the channels to the PCI slot numbers,
to prevent the changing of board numbers to break the setup.
The configuration screen on the webadmin has changed the ease configuration