TROUBLESHOOTING:SLVR issues identified after an Amethyst inS

[John Richard Procter]

SLVR:

1. Problem: The SLVR doesn't trigger to start recording.
   Resolution: The trigger level is set too high. Set the
   trigger lower [Refer to 'How to set your trigger level']
   
2. Problem: The SLVR starts recording and doesn't stop.
   Resolution: The trigger level is set too low. Set the
   trigger level higher [Refer to 'How to set your trigger level']
   
3. Problem: The SLVR doesn't trigger or start recording.
   The vox bar doesn't move, even when the trigger level is dropped
   to the minimum.
   Resolution: The audio cable is not plugged into the
   microphone port of the sound card. Plug the audio cable into
   the microphone port.
   
4. Problem: The SLVR doesn't trigger. The client starts
   recording when Windows sound plays.
   Resolution: The incorrect recording device is selected.
   Select only the microphone as the recording device. Set the volume
   to about 90 % and mute the microphone playback. Also ensure that
   the correct sound card is set as the preferred recording sound card.
   
5. Problem: The SLVR doesn't trigger or record at all.
   Resolution: The microphone recording volume is set too low.
   Set the microphone volume higher. Try at least 90%. If this is too
   loud, try decreasing it in small intervals until the correct
   volume has been found. [Refer to 'How to set your trigger level']

TROUBLESHOOTING:Tests to check USBClient and SLVR setup
TROUBLESHOOTING:Terms used with Amethyst
TROUBLESHOOTING:SLVR issues identified after an Amethyst installation
TROUBLESHOOTING:Problems common to SLVR and USBClient
TROUBLESHOOTING:USBClient problems
TROUBLESHOOTINGSettings in Topaz when using Amethyst
TROUBLESHOOTING:Amethyst Supervisor
TROUBLESHOOTING:Amethyst Server
TROUBLESHOOTING:Other general configuration problems