Can TOPAZ (PABX3) receive the rawdata via the network

[John Richard Procter]

PABX3 request the PBX unit to send data:

PABX3 will open a TCP connection to the buffer/PBX to receive data.

This is when PABX3 connects to the buffer/PBX via a TCP connection and the buffer/PBX
sends data via that connection to PABX3.

Settings under PABX3:

Goto PABX3 -> OPTIONS -> NETWORK

1. tick "Enable Network"
2. enter the "listen port" (Default: 25001)
3. enter the TOPAZ IP and port (Default: 127.0.0.1 and 25000)
   
4. tick "Enable TCP connect"
   (This follwoing information should be available from the buffer suppliers)
5. enter the IP address of the PABX/buffer
6. enter the port number that the PABX/buffer is listening on (default 25100).
   (In some cases a single command or password has to be given on initial connection.
   If so do the following as well)
7. enter the password or command in the password box.

In the case of a buffer, depending on the buffer, you might have to enter
a command to instruct the buffer to start sending off the data.


PABX3 listens(waits) for the buffer to send data to it:

PABX3 will wait for the buffer to establish a TCP connection with it and then
send data to the specified TCP listen port.


This is when the PABX3 opens a TCP session
on the specified IP address and port number and waits
to receive data from the PABX unit.

Settings under PABX3:

In PABX3 -> OPTION -> NETWORK

1. tick "Enable Network"
2. enter the "listen port" (Default: 25001)
3. enter the TOPAZ IP and port (Default: 127.0.0.1 and 25000)
   
4. tick "Enable TCP SMDR port (listen only)"
   This is supplied by the buffer/PBX supplier or technician. This value
   is set on the buffer.

ALSO SEE: How can PABX3 receive data from the PABX Unit?