Basic setup required on Panasonic TDA for TNG Callbarring

[Belinda Frick]

Panasonic TDA PABX configuration for barring with TNG:

For CTI link card 'bar on Rand' is used (not bar on time).

1. Pin Code Security code must be 1 digit (5th confirmation digit)
   
   See page 2 of 'Pansonic TDA Installation Manual.pdf' document under 'Account Code' section for 'Security Code(Pin)'.
   
   Document is installed by default in the folder:

   Code: Select all

   C:\Program Files\Datatex\Panasonic TDA\Docs

   
   
   
2. Group number on PABX must be set.
   
   Group number to forward line back can be for example 601
   
   See page 2 of 'Pansonic TDA Installation Manual.pdf' document under 'Account Code' section for 'Gateway Group'.
   
   Document is installed by default in the folder:

   Code: Select all

   C:\Program Files\Datatex\Panasonic TDA\Docs

   
   
   
3. When selecting the Group number the extension prefix must be set - by default it is zero. If not set it can't barr. For example if the extension prefix is not set and the extension range starts with 2, it will expect extensions starting with '0'.
   
   On PABX side Enable call forward to CO for all Class of Service
   
   See page 2 of 'Pansonic TDA Installation Manual.pdf' document under 'Account Code' section for 'Gateway Group'.
   
   Document is installed by default in the folder:

   Code: Select all

   C:\Program Files\Datatex\Panasonic TDA\Docs

   
   
   
4. Then TNG will control the call barring - as per budgets set.
   
   Configure on TNGCallbarring:
   
   
   • Select barring option, for example account code:
     
     tng_callbarring-tda-1.jpg
     
     
   • enter group number and extension prefix
     
     tng_callbarring-tda-2.jpg